John Deere 345 Drive Belt Routing. I purchased the three idler pulleys to replace with my drive belt. I can not seem to get it to fit over the pulleys.
Web 54 mower deck parts for 345. What is the fastest easiest way to change it. All the details in 10 minutes.
Taken With An Iphone Or Ipad And The Image Is Reversed, Or There Was A Design Change On The 345 Traction Drive Belt System At Some Point.
Jd2007 mytractorforum.com x700, x720, x724, x728, x729 * these machines are shaft driven therefore they have no traction drive belt. Web gx345 traction belt replacement. Web john deere lawn & garden belt routing guide all images belong to john deere document created by:
Can Someone Give Me The Belt Routing Info For This Mower?
Then install the new belt the same way, by routing it over a fan blade and spinning the fan by hand, slowly working the belt down onto the pulley. What is the fastest easiest way to change it. I learned when the 185 crapped the hydrostatic belt that there can be many ways to route a belt but only one is the correct way so i should ask if i can’t find a definite answer on the web.
I Have A Jd 345 With A 54C Deck.
My tractor belt had been on the inside of that bar. Very tight quarters in that area. My problem is the drive belt has been popping off sometimes twisted and deformed or just burns off.
You'd Think Deere Would Put The Diagram On The Deck.
Web i simplify the task of changing the main drive belt on a john deere tractor/transmission belt on a john deere tractor.the particular tractor is how to change a drive belt on a john. With 6 pulleys, it's tough to figure out. Still can not get the new belt to fit.
I Do Recall Looking Up The Traction Drive Asm In A Manual And Seeing That Same Idler Reverse From What It Is On My 345.
Web 54 mower deck parts for 345. I needed the pto's control cable disconnected. Web the blade belt disintegrated on my 345's 48 deck while mowing and left me little to go by on how it should be routed.