How To Set Up Inter-Vlan Routing On Cisco Switch. It also provides guidelines, procedures, and configuration examples. Even though this command is usually enabled, it does not hurt to be certain that it is.
Web configuration of nexus core l3 switch. As the single broadcast domain. Enable routing capability on the switch.
First Create The Layer 2 Vlans.
This document describes the steps to configure and troubleshoot that are applicable to the creation of layer 3 interfaces. Step 2 at the cli command prompt of. First of all, create two vlan in the switch and named vlan a and vlan b with the following command.
Even Though This Command Is Usually Enabled, It Does Not Hurt To Be Certain That It Is.
Web configuration of nexus core l3 switch. Web vlan is the logical grouping of devices in the same or different broadcast domains.by default, all the switch ports are in vlan 1. Web 10 understanding and configuring vlans.
Switch (Config)#Ip Routing Step 2:
Next configure the physical interfaces (trunk ports and routed. As the single broadcast domain. Each router interface was connected to a switch.
It Also Provides Guidelines, Procedures, And Configuration Examples.
Now create the layer 3 svi interfaces. This chapter describes vlans on catalyst 4500 series switches. Web here’s how to configure this: