Cisco Static Routing Configuration. Router (config)#ip route 10.10.23.0 255.255.255.0 10.10.11.2</p> The routing table and route selection;
This chapter includes the following sections: You must configure a floating static route with a higher administrative distance than the dynamic route that it backs up. Web to assign static routes to the particular router:
A Floating Static Route Is A Static Route That The Router Uses To Back Up A Dynamic Route.
Web to assign static routes to the particular router: The switch does not support routing protocols. A static route with a high administrative distance is called a floating static route.
About Static Routing And Default Routes.
Unless otherwise noted, the term switch refers to a standalone switch and a switch stack. I then jump straight into cli and show you how to. Then type the commands and ip information given below.
Static Routing Is Supported Only On Switched Virtual Interfaces (Svis) And Not On Physical Interfaces.
Think like a packet more on our blog: Web configure static routing using cisco packet tracer. Web this module describes how to configure ipv4 unicast routing on a device.
About Virtual Routing And Forwarding;
The first one is static routing and the other one is dynamic routing. Setting up a practice lab Router(config)#ip route 192.168.2.0 255.255.255.0 11.0.0.2</p>
Web R1 Ip On The Wan Link:
Web in order to configure static routing in cisco ios routers, this is the command to use. The routing table and route selection; Static routes are useful for smaller networks that has only one path to the outside networks.